# Easel Settings for SainSmart Prover 4030
**URL:** https://community.inventables.com/t/easel-settings-for-sainsmart-prover-4030/120086
**Category:** 3rd Party Machines
**Created:** [July 12, 2021, 6:58pm UTC](https://community.inventables.com/t/easel-settings-for-sainsmart-prover-4030/120086 "2021-07-12T18:58:44Z")
**Posts on this page:** 3
**Page:** 1
### Author:  [@GregorySkok](https://community.inventables.com/u/GregorySkok)
#### Post date: [July 12, 2021, 6:58pm UTC](https://community.inventables.com/t/easel-settings-for-sainsmart-prover-4030/120086/1 "2021-07-12T18:58:44Z")
Absolute beginner here, looking for an easy to understand and use software and I came across Easel. Trying to set it up for my Machine " Sainsmart Genmitsu PROVerXL4030" and I can’t find them anywhere. Rail Size not found, also not sure which motion control my machine uses.
Any help would be appreciated!
Thanks
---
### Author:  [@JasonPrall](https://community.inventables.com/u/JasonPrall)
#### Post date: [August 21, 2021, 5:52am UTC](https://community.inventables.com/t/easel-settings-for-sainsmart-prover-4030/120086/2 "2021-08-21T05:52:19Z")
Did you ever find a solution for this, Been pulling my hair out trying to find the same answer
---
### Author:  [@SethCNC](https://community.inventables.com/u/SethCNC)
#### Post date: [August 21, 2021, 6:22pm UTC](https://community.inventables.com/t/easel-settings-for-sainsmart-prover-4030/120086/3 "2021-08-21T18:22:40Z")
Record your grbl settings first! It has been reported many times that 4030xl will have ALL grbl settings erased when you go through the machine setup.
It is a best practice to go to machine\>advanced and export the gcode and use a dedicated gcode sender like candle, UGS, or Openbuilds to send the gcode with a 4030xl machine
> [@JasonPrall](#):
>
> Did you ever find a solution for this