Dewalt 611 installation questions

[ErikJenkins]

Here is where I describe how mine is connected:

The build is on!

OK, sorry this took so long. I am using the relay at the bottom of this post to start and stop my Dewalt with my G-Code (I use UGS, I assume it will work with Easel and Chilipeppr as well)…here is how I have wired it up: On the power supply where I marked an “A” the positive wire goes to the Arduino header pin 11. The ground wire goes to the Arduino ground. On the power supply where I marked a “B” the positive goes to the positive relay input and the ground wire goes to the ground input on t…