Cutting bits

[CoreyMitchell]

Latest attempt at relief carving

This design was bought on ebay and then the gcode was made in artcam. The roughing was done with a 3mm flat bit and the finishing was done with a 1.5mm bullnose. The roughing I did with easel but i was not able to make easel work on the finishing pass. Easel kept crashing when it was supposed to start carving. I ended up using G code sender for the finishing pass. I’m guessing that it was just to much data for Easel to process. The g-code file for the finish is 20MB. [image]

Here’s one of the most recent examples that someone posted using a bullnose to do a relief cut (2.5D).