Cut depth done in XCarve is a lot more than that defined in Easel

[RonSabourin]

@YangHuang

do you mind sharing where to set the plate thickness in Easel?

Check this link…

X-Controller with touch Probe, Touch Probe not accurate

Hi Lane, Sorry, had company … … You need to go thru the tab titled “Machine” -(IN EASEL) then “Set up Machine” - run through the set up until you get to this screen… [image] Hit Yes, and then go to “advanced settings” (after attaching your probe) [image] Measure your plate and input the appropriate height… mine was off by a good .02" [image]