Inventables Community Forum

Current calibration procedure on the X-Controller using vref?

X-Carve Upgrades

LarryM March 19, 2017, 3:02pm 19

Take a look at this video:

1 Like

Topic		Replies	Views	Activity
Adjusting x-controller power to motors? Troubleshooting	2	2251	May 13, 2017
Adjusting motor current/voltage Troubleshooting	56	23822	December 15, 2015
The X-controller and 262 Oz. NEMA 23's Upgrades	1	1351	October 27, 2016
18 tooth v 20 tooth pulleys with X-controller X-Carve	1	1781	March 18, 2017
X-Carve Upgrade (XController) Feed rate issues X-Carve	11	3977	November 16, 2016