Consistent tracking issue with projects...help!

[ErikJenkins]

No, it is done of the G-Shield…check out this post it appears to be your Y-Axis:

Adjusting motor current/voltage

Hi, I’m still having a few issues with losing position on the X & Y axis occasionally (1000x1000 X-Carve). I’m tending to suspect that it’s an electrical issue (I’m not a sparky, so after checking all the mechanical stuff, I guess I always ‘blame’ the electronics). My question is this: Is there an easy way for me to measure and then set, the current (and or voltage) that I’m sending to the stepper motors? I understand the basic difference between current and voltage and have a good quality me…