Chatter Issue

[DavidSohlstrom]

This is what I had to offer to another user that is having the same problem.

Good grief 10ipm is boring

OK Plugging those numbers into Gwizard running conservative speeds Depth of cut (DOC) .05 Width of cut (WOC) .25 Feed rate (IPM) 103 Plunge rate 51 Now with the stock spindly spindle that X-Carve ships with you will never get the that feed rate. You may improve things a bit if you can reduce your tool stick out to 1" or better. If I am reading @BillArnold correctly you are limited to .5" of your tool fitting in the collet before it bottoms out. That is not good. Also as Bill said a 1/8" …

Dave