I made a dish and carved in the flat interior like you’re wanting to do (see here: Prints and Poop (Kimberly's Corner)). After making the bowl and staining it, I made the face design in Easel, centered around 0,0, then homed my spindle to the center of where I wanted the face to be. Before I carved I ran the simulation as a precaution, but I didn’t have to worry… the spindle never traveled so far that it could touch the sides of the bowl.
Related topics
| Topic | Replies | Views | Activity | |
|---|---|---|---|---|
| Curious on different ways to accomplish this piece | 8 | 1499 | April 25, 2019 | |
| Finishing Pass cutting air | 4 | 761 | March 28, 2021 | |
|
Is there a way to avoid this
|
5 | 368 | January 31, 2022 | |
| My project isn't carving as set up in easel | 49 | 2468 | November 16, 2020 | |
|
Home path cuts deeper than the rest
|
13 | 358 | March 1, 2024 |