According to the videos and instructions, they say to use small plastic washers to install over the 3mm shcs’s that hold the Arduino board down without shorting things out. I have looked all over every package and cannot find those three little plastic washers. Do they still need them? Can I use something else in their place? Looking good so far, thanks for the help in advanced.
Ron
Off the top of my head I think it had said you don’t need plastic washers. I didn’t have any and my installation works properly.
What Rusty said…
I looked through the instructions and there is a highlighted note that said “Nylon spacers are not required to mount the Arduino to the enclosure.” Follow this link…under step 7. Here
Thanks, I knew I had to have missed something along the way.