# Anyone in Toronto GTA? **URL:** \ **Category:** Uncategorized\ **Created:** [August 9, 2018, 12:28am UTC](https://community.inventables.com/t/anyone-in-toronto-gta/59004 "2018-08-09T00:28:54Z")\ **Posts on this page:** 1\ **Showing post:** 5
**Author:** ![darrin1200](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/darrin1200/32/85480_2.png) [@darrin1200](https://community.inventables.com/u/darrin1200)\ **Post date:** [August 9, 2018, 12:49pm UTC](https://community.inventables.com/t/anyone-in-toronto-gta/59004/5 "2018-08-09T12:49:01Z")
I wouldn’t worry about it to much Mathew, it takes a while to pick up on forum etiquette. I wouldn’t worry about a city name either. Most people I speak to outside the GTA, don’t even know that there is a “Toronto”. They figure Toronto and GTA are the same thing. Wish I was closer, I could give you a hand, but I’m a few hours east of the GTA. Once you figure out the basics of what Gcode is and how it talks to your machine, ie Machine Inspector, it gets easier. Here is a pretty good thread > [@Stepper Motor Calibration](https://community.inventables.com/t/stepper-motor-calibration/43305): > > So I’ve been playing around with my X-Carve for about 6 months now, doing basic signs, a few boxes. cut outs, etc. neat stuff, but nothing that needed to be dead accurate until now. I was using the X-Carve to make some blind holes for some cam connectors to be placed in (you know, like you have in IKEA furniture). When I went to place the cam in the hole, I noticed that it wasn’t quite circular, but was actually slightly oval. It’s supposed to be 15mm diameter, but is more like 14.99 x 15.27 (… I am by no means an expert, and I am still struggling to figure a lot of this stuff out. But if you have any specific questions, shoot me a PM. Maybe we can set up a chat on the phone. Darrin --- _[View the full topic](https://community.inventables.com/t/anyone-in-toronto-gta/59004)._