Another attempt at carving a photo!

[AllenMassey]

OK Folks, any help would be appreciated!

James, Not sure what you did, but I downloaded the Vcarve photo software from Vectric and used the sample picture they provide (puppies). I carved it using a 90 deg vbit and while it did carve it correctly the picture was not really visible. I did the same picture again with a 60 deg vbit and it looked a little better but it was still not a good picture. The last one I did was with a 30 deg vbit and it was even better. What I learned - FIrst issue was that when I generated the Gcode using …