# 3rd Party Stepper Drivers (no gshield)

**URL:** <https://community.inventables.com/t/3rd-party-stepper-drivers-no-gshield/13266>\
**Category:** Assembly\
**Created:** [September 16, 2015, 8:45pm UTC](https://community.inventables.com/t/3rd-party-stepper-drivers-no-gshield/13266 "2015-09-16T20:45:38Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![JeffKing](https://avatars.discourse-cdn.com/v4/letter/j/94ad74/32.png) [@JeffKing](https://community.inventables.com/u/JeffKing)\
**Post date:** [September 16, 2015, 8:45pm UTC](https://community.inventables.com/t/3rd-party-stepper-drivers-no-gshield/13266/1 "2015-09-16T20:45:38Z")

</div>

I have some third party stepper drivers that I would like to use. Is there a schematic somewhere that shows how to wire these directly to the arduino?

---

<div class="post-metadata">

**Author:** ![AllenMassey](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/allenmassey/32/84441_2.png) [@AllenMassey](https://community.inventables.com/u/AllenMassey)\
**Post date:** [September 16, 2015, 9:04pm UTC](https://community.inventables.com/t/3rd-party-stepper-drivers-no-gshield/13266/2 "2015-09-16T21:04:11Z")

</div>

You can start here

> **[Connecting Grbl](https://github.com/grbl/grbl/wiki/Connecting-Grbl)**
>
> An open source, embedded, high performance g-code-parser and CNC milling controller written in optimized C that will run on a straight Arduino - grbl/grbl

---

<div class="post-metadata">

**Author:** ![JeffKing](https://avatars.discourse-cdn.com/v4/letter/j/94ad74/32.png) [@JeffKing](https://community.inventables.com/u/JeffKing)\
**Post date:** [September 16, 2015, 9:08pm UTC](https://community.inventables.com/t/3rd-party-stepper-drivers-no-gshield/13266/3 "2015-09-16T21:08:15Z")

</div>

Perfect, thanks.