I’ve had 2 of my 1/16 ball nose bits with a 1/8" shank snap recently. Would my feed rate or plunge rates be too high that would cause them to bind? The first one I watched as it was carving and it was carving across the plane of the wood and snapped, no real binding on it.
Each time I switch to a 1/8 ball nose with a 1/4 shank and have no issues, but I’m trying to get more detail than that bit provides.
How do I keep them from snapping?
Thanks.
What settings were used for the instance where they snapped? Can you post a photo of the carve where the bit broke, and the cut settings used (feedrate, plungerate, etc)
I didn’t get a pic, but it was about 5 minutes into a 3d carve of a butterfly. The first time I was working on a dragonfly. Each time one has snapped, it’s been in the initial stage as it’s starting to shape the edge of whatever I’m carving.
Settings were 90 in/min feed rate, 36 in/min plunge, 8% step over, spindle speed 16k rpm.
My guess is maybe the plunge rate is too aggressive?
You can get a 1/16 ball nose or smaller in 1/4" shank. That would be the best option.
I use this for fine detail it is less that 0.04" radius.
https://www.amazon.com/gp/product/B015C6CHUC/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
Oh, youre doing 3d finishing passes…
A tapered ball bit would be more appropriate for this and the taper geometry make them much stronger than straight sided ball bits.
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.